

Under this Ares find instructions on the official forum of Raspberry Pi how to configure the card TP-Link TL-WN725N.


Files, you can compile under this OS version, description of how to do this can be found on the forum. If drivers are not compatible with the current version of the operating system will appear the message: ERROR: could not insert ’8188eu. Network settings can be done through the app WiFiConfig, to which the label is by default on the desktop. Sudo install-p-m 644 8188eu.ko /lib/modules/`uname -r`/kernel/drivers/net/wirelessĪfter these steps, the card must be properly installed. The next step is to issue several commands in the console (icon on desktop): In place xyyzz you must specify the appropriate version of software for your Linux. You should find the right drivers on that page, download them and unpack by typing the commands : OpenWRT firmware OpenVPN client for TP-Link routers with small flash. For the system Raspbian with kernel 3.18 below TP-LINK EAP245 AC1750 Wireless Dual Band Gigabit Ceiling Mount Access Point.Sudo wget -On /lib/firmware/rtlwifi/rtl8188eufw.binĪfter rebooting the Raspberry Pi, the adapter should be properly installed. In this version, you must download and install the software, including to just call a single command: For the system Raspbian with kernel version 3.18.5.To check the version of Linux you can issue the following command You must select the appropriate drivers for your version of the operating system Raspbian: Installation of the system and start the WiFi on the Raspberry Pi. The whole operation is not complicated, takes only a few minutes. The files you need to download and install yourself. Network card TP-Link TL-WN725N version 2 does not have a default driver in the system Rasbpian. iNode - sensors and modules Bluetooth AndroidĬonfiguration of the TP-Link TL-WN725N WiFi cardĬonfigure WiFi card TP-Link TL-WN725N for the system Raspbian - Raspberry Pi.Components for 3D printers construction.Laser cutting machines - engravers, plotters.
